SERIES 60 SERVICE MANUAL 5. Reassemble breather housing to valve cover cap. See Figure 1-106. Torque the screws to 2.5 N·m (22 lb·in.). 1. Two-Piece Valve Rocker Cover Cap 6. Retainer 2. Retainer Clip 7.Two-Piece Low Profile Rocker Cover Cap 3. Wire Mesh Element 8. Seal 4. Screw 9. Breather Housing 5. Baffle Figure 1-106 Two-piece Rocker Cover Assembly 1.6.4 Removal and Precleaning of Two-Piece Rocker Cover-Gas Engines with Coil Over Plug Ignition System Only Preclean the rocker cover, especially around its base on the cylinder head and in the attaching bolt recesses to keep dirt and debris out of the valve gear chamber. To remove the two-piece rocker cover: 1.
Remove the ignition boots from the spark plug wells. Refer to section 16.4.1. 2. Lift the cap off the base leaving the six extensions tubes in the cylinder head. 3. Blow any excess oil from the outside of the extension tube so that the oil will not enter the spark plug well when the extensions tubes are removed. 4. Pull the six extension tubes from the cylinder head. 5. Loosen and remove the ten bolt/isolator assemblies that attach the base to the cylinder head. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-119