Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.6 ROCKER COVER 6. Lift the base straight up off the cylinder head. 1.6.5 Removal and Cleaning of Three-piece Rocker Cover Preclean the three-piece rocker cover, especially around its seat on the head, and in the attaching bolt recesses, to keep dirt and debris out of the valve gear chamber. Perform the following steps to remove the three-piece rocker cover: 1. Remove the eight screws that attach the rocker cover cap to the intermediate cover. See Figure 1-104. 2. Lift the cap off the intermediate cover. 3. Loosen and remove the eight bolts that attach the intermediate rail to the base. 4. Lift intermediate off the base. 5.

Loosen and remove the ten bolt/isolator assemblies that attach the base to the cylinder head. 6. Lift the base straight up off the cylinder head. Before inspecting the rocker cover, clean the isolators as follows: NOTICE: To avoid damaging isolators, do not use solvents of any kind, or any petroleum distillates to clean them. The isolators can be cleaned with mild soap and water if necessary. Install new seals and isolators clean and dry. 1. Wash isolators with mild soap and water. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2.

Be sure to completely dry gasket grooves in the rocker cover with compressed air. 3. Use new gaskets (do not reuse old gaskets). NOTICE: Reuse gaskets with manufacturing date after May 28, 1999. 4. Inspect the lower rocker cover base-to-cylinder head gasket for damage replace if gasket is damaged. (Rev. 2005) All information subject to change without notice. 1-120 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION