Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 5. If gasket is not damaged clean off excess RTV, clean gasket with clean fuel oil dry completely and reuse part. 1.6.5.1 Inspection of Three-piece Rocker Cover Inspect the three-piece valve cover as follows: 1. Wash the components in clean fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Blow dry with compressed air. 3. Clean the breather recess in the rocker cover. 4. Check for damage. Replace as necessary. 1.6.6 Disassembly of Rocker Cover Disassemble the rocker cover as follows: 1.

Disengage the clip that holds the crankcase vent breather element in the valve cover by pressing the center of the spring steel retaining clip outward and removing the straight end. 2. Rotate the clip upward to remove the curved end. 3. Remove the wire mesh element. 1.6.7 Pre-installation of Rocker Cover Preform the following steps prior to installing the rocker cover: 1. Install the rocker cover seal in corners of the camshaft cap section (arch at each end of the valve cover) first. NOTE: Be sure the rocker cover grooves and the seals are clean, free of oil and dry. 2. Install the cam cap section, starting in the center, by pushing the seal into the groove at the top of the arch.

Then install each section at its halfway point. Seat the seal completely around the arch. Be sure the corners are still firmly seated after the arch is completed. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-121