Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.6 ROCKER COVER They should present a square corner parallel to the rocker cover rail. Repeat this procedure for the cam cap section on the other end. See Figure 1-107. Figure 1-107 Rocker Cover Gasket Installation 3. Install the long runs of the gasket starting in the center, by pushing the seal into the groove. 4. Then install the rail portion at each halfway point. Repeat this procedure for the other rail portion. Make sure the seal is completely seated all the way around the valve cover. NOTE: The corners must be cleaned prior to RTV installation for best results. (Rev. 2005) All information subject to change without notice. 1-122 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION