SERIES 60 SERVICE MANUAL 5. Apply a small 4.75 mm (3/16 in.) fillet of RTV in the corners formed by the rear camshaft cap and the head, where the cover seal contacts. Repeat this procedure for the corners formed by the front camshaft cap and the head. See Figure 1-108. Figure 1-108 RTV Installation 1.6.8 Installation of One-Piece Rocker Cover Perform the following steps to install a one-piece rocker cover: 1. Position the rocker cover on the cylinder head. 2. Install the two bolts, with isolators and washers installed, into their recesses in the one-piece rocker cover. 3. Torque the two bolts, starting with the center bolts and working out, to 20-25 N·m (15-18 lb·ft). 4.
Press the two protective plugs into the two center holes until they are firmly seated. 5. Install any other components that were removed for their procedure. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-123