Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.6 ROCKER COVER Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. PERSONAL INJURY 6. Start the engine and check for leaks. 1.6.9 Installation of Two-Piece and Three-Piece Rocker Covers Perform the following steps to install a two or three-piece rocker cover: 1. Position the rocker cover base on the cylinder head. 2.

Lubricate the valve cover limiting sleeves with clean silicone spray. Insert the sleeves into the isolators until the end of the sleeve is flush with the isolator. See Figure 1-109. 1. Limiting Sleeve 3. Bolt 2. Isolator 4. Flat Washer Figure 1-109 Rocker Cover Base Hold Down Hardware 3. Install the hold-down bolts, with washers installed, to the limiting sleeves. (Rev. 2005) All information subject to change without notice. 1-124 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION