1.6 ROCKER COVER 5. Torque the ten rocker cover base hold-down bolts to 30-38 N·m (22-28 lb·ft). See Figure 1-111. NOTE: Torque the bolts in two stages, using half-torque values first. Figure 1-111 Rocker Cover Base Bolt Tightening Sequence 6. Be sure the groove in the top of the rocker cover base, and its mating, diamond-shaped seal are clean and dry. Install the diamond-shaped seal to the groove by pressing the seal into the groove. Use care not to stretch or twist the seal. The seal has a definite shape, and should be installed exactly as removed from the base. If the seal cannot be installed to its groove without bunching or looping, the seal is stretched and must be replaced.
The same procedure applies to the intermediate cover diamond seal installation. (Rev. 2005) All information subject to change without notice. 1-126 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION