SERIES 60 SERVICE MANUAL 7. Install the rocker cover cap to the base. Install the eight screws that attach the cap to the base, and torque to 22-25 N·m (16-18 lb·ft) using the torque sequence. See Figure 1-112. Tighten the bolts in two stages, using half-torque value first. The same procedure applies to the intermediate cover installation. Figure 1-112 Rocker Cover Bolt Tightening Sequence 8. Install any other parts that were removed for this procedure. 9. Refer to section1.6.8 for the exhaust caution before preceeding. Start the engine and check for leaks. Shutdown engine after checking for leaks.
1.6.10 Installation of the Two-Piece Rocker Cover Cap - Diesel Engines Only Install the two-piece rocker cover as follows: 1. Be sure the groove in the bottom of the rocker cover base, and its mating, diamond-shaped seal are clean and dry. Install the diamond-shaped seal to the groove by pressing the seal into the groove. Use care not to stretch or twist the seal. The seal has a definite shape, and should be installed exactly as removed from the base. If the seal cannot be installed to its groove without bunching or looping, the seal is stretched and must be replaced. The same procedure applies to the intermediate cover diamond seal installation. 2. Install the rocker cover cap to the base.
Install the eight bolts that attach the cap to the base, and torque to 22-25 N·m (16-18 lb·ft) using the torque sequence. See Figure 1-113. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-127