Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.6 ROCKER COVER Tighten the bolts in two stages, using half-torque value first. The same procedure applies to the intermediate cover installation. Figure 1-113 Rocker Cover Bolt Cap Tightening Sequence 3. Install any other parts that were removed for this procedure. 4. Refer to section1.6.8 for the exhaust caution before preceeding. Start the engine and check for leaks. Refer to section 12.7. 1.6.11 Installation of the Two-Piece Rocker Cover Cap (Gas Engines with Coil Over Plug Ignition System Only) Install the two-piece rocker cover cap as follows: 1. Clean any oil or dirt from the spark plug wells. 2. Insert the six extension tubes with O-rings in the cylinder head. 3.

Orient the extension tubes so that twelve threaded holes are in a straight line. This will allow the coil mounting bolts to engage these holes after the rocker cover cap is installed. 4. Place the rocker cover cap on base without disturbing the extension tube seals. Loosely install the eight bolts that attach the cap to the base. 5. Insert the coils into the spark plug wells. Engage the coil mounting bolts into the extension tubes. Torque the bolts 13-16 N·m (10-12 lb·ft). 6. Torque the eight rocker cover cap mounting bolts to 22-25 N·m (16-18 lb·ft). 7. Install the remaining ignition system parts. Refer to section 16.2. 8.

Apply antiseize compound to the coil cover mounting screw holes to aid removal of these parts in the future. 9. Install any other parts that were removed for this procedure. 10. Refer to section1.6.8 for the exhaust caution before preceeding. Start the engine and check for leaks. Refer to section 12.7. (Rev. 2005) All information subject to change without notice. 1-128 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION