1.7 CRANKSHAFT Full pressure lubrication to all connecting rod and main bearings is provided by drilled passages within the crankshaft and cylinder block. See Figure 1-120. Figure 1-120 Crankshaft Lubricating Oil Holes Six or twelve tapped holes, equally spaced, are provided on the rear butt for attaching the flywheel. There are six or twelve equally spaced tapped holes on the front butt of the crankshaft for attaching the crankshaft pulley and vibration damper. No locating dowels are provided at either end. Each standard main bearing journal is 125.000-124.968 mm (4.921-4.920 in.) in diameter and each standard connecting rod journal is 85.000-84.975 mm (3.346-3.345 in.) in diameter. (Rev.
2005) All information subject to change without notice. 1-134 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION