Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL New crankshafts with smaller radii fillets (listed in Table 1-2) replaced the former crankshafts, effective with the following engine serial numbers: Table 1-2 New Crankshafts with Smaller Radii Fillets This change was made to permit installation of new, wider connecting rod bearings that increase rod bearing oil film thickness and reduce bearing pressures. The fillets on the new crankshafts have a radius of 4.0-3.5 mm (0.157 -0.138 in.). The fillets on the former crankshafts had a radius of 6.0-5.5 mm (0.236 -0.216 in.). To conform with this change, new connecting rods with smaller rod chamfers were also released.

Refer to section 1.22for information on the new connecting rods and bearings. The new crankshafts, bearings, and connecting rods must be used together to ensure interchangeability. Former parts cannot be mixed with new parts in the same engine. The former crankshafts will no longer be available. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-135 Engine Model Engine Serial Number 6067WK60 (11.1 L) 6R184522 6067GK60 (12.7 L) 6R188251