SERIES 60 SERVICE MANUAL 1.7.2 Removal and Cleaning of Crankshaft When removal of the crankshaft becomes necessary, first remove the transmission, then proceed as follows: 1. Steam clean the exterior of the engine. Refer to section 1.1.3. 2. Drain the cooling system. Refer to section 14.6.4. 3. Drain the lubricating oil. Refer to section 14.6.1. 4. Attach suitable chain hoist and spreader bar with hooks to the three lifter brackets (one at the front and two at the rear). Remove all engine to base attaching bolts and remove the engine from its base. Refer to section 1.1.2. See Figure 1-5.
FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. 5. Remove and inspect all of the accessories and assemblies with their attaching parts as necessary to permit the engine block adaptor, to be bolted to the intake (left) side of the cylinder block. Mount the engine to the overhaul stand (J–29109) with adaptor (J–35635–A) attached. Refer to section 1.1.2. 6. Remove the oil pan, refer to section 3.11.2. 7. Inspect the oil pan, refer to section 3.11.3.1. 8. Remove the lubricating oil pump, refer to section 3.2.2. 9. Inspect the lubricating oil pump, refer to section 3.2.3.1. 10.
Remove the flywheel, refer to section 1.16.2. 11. Inspect the flywheel, refer to section 1.16.2.1. 12. Remove flywheel housing, refer to section 1.18.2. 13. Inspect the flywheel housing, refer to section 1.18.2.1. NOTICE: Use care when removing the crankshaft pulley as the vibration damper may come off. If the damper is allowed to fall, damage to the internal components of the damper may result. 14. Loosen and remove two of the crankshaft pulley retaining bolts and hardened washers 180 degrees apart and install two flywheel guide studs (J–36235) in their place. Then loosen and remove the remaining four pulley retaining bolts and hardened washers. Refer to section 1.15.2.
All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-137