Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.7 CRANKSHAFT 15. Remove and inspect the viscous vibration damper. Refer to section 1.14.2, and refer to section 1.14.2.1, for inspection. 16. Remove and inspect the engine front support and gear case cover. Refer to section 1.10.2, for removal and refer to section 1.10.2.1, for inspection. 17. Remove and inspect gear case cover Exhaust Gas Recirculation model, refer to section 1.11.2 for removal and refer to section 1.11.2.1 for inspection. 18. Remove the cylinder head, refer to section 1.2.2. 19. Inspect the cylinder head, refer to section 1.2.3.1. 20. Loosen and remove the main bearing cap bolts. Remove the main bearing caps for inspection. Refer to section 1.9.2. NOTE:

The connecting rod caps must be reinstalled to their respective connecting rods. The main bearing caps should be kept in sequence, so that they may be installed to their original positions. 21. Remove and inspect the piston and connecting rod assemblies. Refer to section 1.21.2 for removal and refer to section 1.21.3.1. 22. Remove and inspect the thrust washers from each side of the No. 6 main bearing cap, if they exist. (Engines with a serial number greater than 6R-6287 do not have thrust washers on the No. 6 main bearing cap.) Refer to section 1.9.2.2 for inspection. 23. Remove and inspect the crankshaft, including the crankshaft gear and timing wheel.

Refer to section 1.7.2and refer to section 1.7.2.1. 24. Remove the timing gear and timing wheel, refer to section 1.24.2and inspect it, refer to section 1.24.3. 25. Remove the Woodruff key from the slot in the front crankshaft hub. 1.7.2.1 Inspection of Crankshaft Perform the following steps for crankshaft inspection: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Clean out the oil passages thoroughly with a stiff wire brush. Clean the crankshaft with fuel oil and dry it with compressed air. (Rev. 2005) All information subject to change without notice.

1-138 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION