Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2. Inspect the crankshaft timing gear keyway for evidence of cracks or wear. Replace the crankshaft if these conditions are evident. 3. If the crankshaft shows evidence of excessive overheating, replace the crankshaft since the heat treatment has probably been destroyed. 4. Check the crankshaft journal surfaces for score marks and other imperfections. If excessively scored, the journal surfaces must be reground. Refer to section ADDITIONAL INFORMATION 1.A, "Main and Connecting Rod Journals". 5. Carefully, inspect the front and rear end of the crankshaft in the area of the oil seal contact surface for evidence of a rough or grooved condition.

Any imperfections of the oil seal contact surfaces will result in oil leakage at these points. 6. If the crankshaft oil seal contact surfaces are grooved, the seal surfaces must be sleeved and an oversized seal used. Refer to section 1.8.2. 7. Check the crankshaft thrust surfaces for excessive wear or grooving. If excessively worn, the thrust surfaces must be reground. Refer to section ADDITIONAL INFORMATION1.A, "Machining Operations". 8. Check the crankshaft timing gear for worn or chipped teeth. Inspect the timing wheel for bent or otherwise damaged teeth. Replace as necessary. Refer to section 1.34.2.1. 9. Check the crankshaft journal run-out. Refer to section 1.7.2.4. 10.

Check the journal alignment. Refer to section 1.7.2.3. 11. Check the journal measurements. Refer to section 1.7.2.4. 12. Inspect the crankshaft for cracks. Refer to section 1.7.2.1. 1.7.2.2 Crankshaft Journal Run-out Measurements Support the crankshaft on its front and rear journals on V-blocks or the inverted engine block with only the front and rear upper bearing shells in place. Check the intermediate main journals with a dial indicator for run-out when the crankshaft is rotated. When checking the crankshaft bow, if the run-out is greater than that listed in Table 1-3, the crankshaft must be replaced. Table 1-3 Crankshaft Bow All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-139 Journals Supported On Journals Measured Maximum Run-out (Total Indicator Reading) No. 1 and No. 7 No. 2 and No. 6 0.076 mm (0.003 in.) No. 1 and No. 7 No. 3 and No. 5 0.127 mm (0.005 in.) No. 1 and No. 7 No. 4 0.152 mm (0.006 in.)