1.7 CRANKSHAFT 1.7.2.6 Magnetic Particle Method Magnetize the crankshaft and then cover it with a fine magnetic powder or solution. The crankshaft must be demagnetized after the test to avoid engine damage. NOTICE: Very fine cracks may be missed using the magnetic particle method, especially on discolored or dark surfaces. They will be disclosed under the black light. If the crankshaft is discolored or has dark surfaces, the magnetic particle method should not be used. Refer to section 1.7.2.7for suitable alternate method. Flaws, such as cracks, form a small local magnet which causes the magnetic particles in the powder or solution to gather there, effectively marking the crack.
1.7.2.7 Fluorescent Magnetic Particle Method This method is similar to the magnetic particle method, but is more sensitive since it employs magnetic particles which are fluorescent and glow under black light. Refer to section 1.7.2.6. 1.7.2.8 Fluorescent Penetrant Method This is a method which may be used on both non-magnetic and magnetic materials. A highly fluorescent liquid penetrant is applied to the part. Then the excess penetrant is removed from the surface and the part is dried. A developing powder is then applied which helps to draw the penetrant out of the flaws by capillary action. Inspection is carried out under a black light.
A majority of indications revealed by the above inspection methods are normal and harmless and only in a small percentage of cases is reliability of the part impaired when indications are found. Since inspection reveals the harmless indications with the same intensity as the harmful ones, detection of the indications is but a first step in the procedure. Interpretation of the indications is the most important step. All crankshafts are magnetic particle inspected after manufacture to ensure against any shafts with harmful indications getting into the original equipment or factory parts stock.
Crankshaft failures are rare and when one cracks or breaks completely, it is very important to make a thorough inspection for contributory factors. Unless abnormal conditions are discovered and corrected, there will be a repetition of the failure. (Rev. 2005) All information subject to change without notice. 1-142 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION