Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.7 CRANKSHAFT 1.7.2.10 Torsional Fatigue Failures result from torsional vibration which takes place at high frequency. A combination of abnormal speed and load conditions may cause the twisting forces to set up a vibration, referred to as torsional vibration, which imposes high stresses at the locations. See Figure 1-125. Figure 1-125 Crankshaft Fatigue Cracks Torsional stresses may produce a fracture in either the connecting rod journal or the crank cheek in the rear. Torsional failures may also occur at the front end of the crankshaft at the crankshaft timing gear drive key slot. Connecting rod journal failures are usually at the fillet or oil hole at 45 degrees to the axis of the shaft.

A loose, damaged or defective vibration damper, a loose flywheel or the introduction of improper or additional pulleys or couplings are usual causes of this type of failure. Also, overspeeding of the engine or overriding the engine electronic control system to allow engine overspeeding may be contributory factors. 1.7.2.11 Crankshaft Cracks As previously mentioned, most of the indications found during inspection of the crankshaft are harmless. The two types of indications to look for are circumferential fillet cracks at the critical areas and 45° cracks (45° to the axis of the shaft) starting from either the critical fillet locations or the connecting rod journal holes. See Figure 1-125.

Replace the crankshaft when cracks of this nature are found. Refer to section 1.7.3. 1.7.2.12 Crankshaft Grinding The use of properly remanufactured crankshafts is very important to maximize crankshaft main and connecting rod bearing life. (Rev. 2005) All information subject to change without notice. 1-144 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION