SERIES 60 SERVICE MANUAL Remanufactured crankshafts must conform to specifications. See Figure 1-125. The dimensional requirements for journal axial profile, radial chatter and oil hole washout require confirmation with a Gould 1200 Surface Analyzer (or equivalent). Information on Gould 1200 is available in the "Glossary". Refer to section ADDITIONAL INFORMATION1.A. NOTE: Visual inspection cannot be relied upon to confirm the compliance to journal quality specifications. The procedure of crankshaft journal polishing can easily create axial profile and oil hole washout conditions beyond specifications.
Any polishing operation should be followed by Gould 1200 (or equivalent) measurements to assure conformance to remanufactured specifications. Refer to section ADDITIONAL INFORMATION1.A, "Crankshaft Remanufacturing Procedures". All used crankshafts that have not been reground must meet the dimensional specifications standard or be reground to specifications. Refer to section ADDITIONAL INFORMATION1.A, "Crankshaft Remanufacturing Procedures". In addition to standard size crankshaft thrust washers, 0.127 mm (0.005 in.) and 0.254 mm (0.010 in.) oversize thrust washers are available. Thrust surface specifications are listed in Table 1-22.
Remanufactured crankshafts should be stamped on the edge of the No. 1 crank throw (counterweight) with the appropriate undersize dimensions for identification purposes. NOTE: Crankshaft main bearing journals and/or connecting rod journals which exhibit discoloration due to excessive overheating from bearing failure are NOT acceptable for rework. If one or more main or connecting rod journals require grinding, grind all of the main journals or all of the connecting rod journals to the same required size. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-145