1.7 CRANKSHAFT 1.7.3 Installation of Crankshaft Install the crankshaft using the following procedure: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Steam clean it to remove the rust preventive and blow out the oil passages with compressed air. 2. Install the upper main bearing shells in the block. If the old bearing shells are to be used again, install them in the same locations from which they were removed. Refer to section 1.9.3. NOTE:
When a new or reground crankshaft is installed, ALL new main and connecting rod (upper and lower) bearing shells and new thrust washers must also be installed. NOTE: If the crankshaft surfaces were reground, it may be necessary to install oversize thrust washers on one or both sides of the No. 6 main journal. See Figure 1-117. 3. Install the thrust washer upper halves in the counterbores on either side of the No. 6 bearing saddle. Coat the backs of the thrust washers (without oil grooves) with petroleum jelly and stick them in place with the oil-grooved sides facing away from the saddle. 4.
Apply clean engine oil 360 degrees around all crankshaft bearing journals and install the crankshaft in place so that the timing marks on the crankshaft timing gear and the bull gear are aligned. Refer to section 1.24.2.1. NOTE: If timing gear and timing wheel were removed install timing gear and timing wheel prior to installation of crankshaft. Refer to section 1.34.3. NOTE: It may be easier to remove the bull gear assembly and re-time the engine. (Rev. 2005) All information subject to change without notice. 1-146 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION