Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 5. Install the main bearing shells in the main bearing caps as follows: NOTE: Whether the engines were built with or without thrust washers in the No. 6 main bearing cap, they are no longer required; they do not need to be reinstalled. [a] Align the tang on the lower main bearing shell with the groove in the main bearing cap. Install the bearing shell to the main bearing cap. NOTE: The main bearing caps are bored in position and stamped with position number. They must be installed in their original positions, with the marked (numbered) side of each cap toward the cooler (right) side of the cylinder block.

[b] If the old bearing shells are to be used again, install them in the same bearing caps from which they were removed. 6. Install the main bearing caps together with lower bearing shells in place. Figure 1-126 Main Bearing Cap Installation All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-147