Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.7 CRANKSHAFT 7. Apply a small quantity of International Compound #2® (or equivalent) to the bolt threads and underside of the bolt heads. Install the main bearing cap bolts and draw them up snug. See Figure 1-126. Rap the main bearing caps sharply with a fiber mallet or plastic hammer to insure the caps are fully seated. 8. Torque all of the main bearing cap bolts to 470-530 N·m (347-391 lb·ft). Begin at the center caps and work progressively toward each end. Tighten the bolts to half the specified torque and then repeat the tightening sequence to the torque limit. NOTE:

If the bearings have been installed properly, the crankshaft will turn freely with all of the main bearing cap bolts drawn to the specified torque. 9. Check the crankshaft end by moving the crankshaft toward the gage with a small 304.8 mm (less than 12 in.) pry bar. See Figure 1-127. Keep a constant pressure on the pry bar and zero the pointer on the dial indicator. Then, remove and insert the pry bar on the other side of the bearing cap. Force the crankshaft in the opposite direction and note the amount of end play on the dial. The end play should be 0.099-0.419 mm (0.0039 -0.0165 in.). Insufficient end play can be the result of a misaligned No.

6 main bearing, a misaligned upper thrust washer or a burr or dirt on the inner face of one or more of the thrust washers. Figure 1-127 Measuring Crankshaft End Play (Rev. 2005) All information subject to change without notice. 1-148 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION