Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 10. Assemble the timing wheel and crankshaft gear on the crankshaft. Refer to section 1.34.3. 11. Install the piston and connecting rod assemblies. Refer to section 1.21.5. Torque the connecting rod cap nuts to 160-185 N·m (118-137 lb·ft). 12. Install the cylinder head. Refer to section 1.2.5. 13. Install the flywheel housing. Refer to section 1.18.3. 14. Replace the rear crankshaft seal with new seal and sleeve assembly. Refer to section 1.8.5. 15. Install the flywheel. Refer to section 1.16.3. 16. Install the lubricating oil pump, inlet and outlet pipes. Refer to section 3.2.6. 17. Install the gear case cover and engine front support. Refer to section 1.10.3. 18.

Install gear case cover Exhaust Gas Recirculation model and engine front support refer to section 1.13.2 19. Replace the front crankshaft seal with new seal and sleeve assembly. Refer to section 1.8.5. 20. Install the viscous vibration damper. Refer to section 1.14.3. 21. Install the crankshaft pulley. Refer to section 1.15.3. 22. Install the oil pan. Refer to section 3.11.4. 23. Use a chain hoist and spreader bar with hooks attached to the lifting brackets at each end of the engine and remove the engine from the overhaul stand. See Figure 1-5. 24. Remove the overhaul stand adaptor plate from the engine block. See Figure 1-7. 25. Install any accessories that were removed. 26.

Install the engine to the equipment from which it was removed. 27. Fill the cooling system. Refer to section 14.6.4. 28. Fill the engine crankcase to correct operating level. Refer to section 14.6.1. 29. After replacing the main or connecting rod bearings or installing a new or reground crankshaft, operate the engine as outlined in the "Run-In Schedule." Refer to section 12.7.3.2. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-149