Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.8 CRANKSHAFT OIL SEALS 1.8 CRANKSHAFT OIL SEALS An oil seal is fitted between each end of the crankshaft and the bores of the flywheel housing and gear case cover to retain the lubricating oil in the crankcase. In certain applications, the seal must also prevent transmission oil from migrating into the engine. Seals are pressed into the bores after the housing or cover is assembled to the engine. See Figures 1-128 and 1-129. Figure 1-128 Crankshaft Rear Oil Seal Figure 1-129 Crankshaft Front Oil Seal Current seals feature a lay down sealing lip of low-friction PTFE with unidirectional spiral pumping grooves. An outer dust-exclusion lip keeps airborne dirt away from the primary sealing lip.

The sealing lip does not touch the crankshaft, because an integral wear sleeve provides the running surface and protects the lip during installation. A separate replacement wear sleeve is not needed. The wear sleeve and outer carrier are joined together, forming a unitized seal assembly. Because of the spiral grooves on the sealing lip, a front crankshaft seal will leak if installed at the rear, and a rear crankshaft seal will leak if installed at the front. (Rev. 2005) All information subject to change without notice. 1-150 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION