SERIES 60 SERVICE MANUAL Wet-flywheel-housing applications require a double-lip rear seal to prevent transmission oil from migrating into the engine. This seal is similar to the single lip seals except for the extra lip, and the wear sleeve and outer carrier are not joined together. NOTICE: Failure to use the correct seal according to location on the engine or according to flywheel housing type or application may result in seal damage, oil leakage, or damage to the engine and the vehicle or equipment into which it is installed. All engines may be serviced with the current-production front seal.
However, engines built before serial number 06R0491683 were built with a different design of rear crankshaft seal (dry flywheel housings only). This seal may not be serviced with the current rear seal because the current rear seal requires a cast-in rib on the flywheel housing and block to direct additional oil to the seal for cooling. See Figures 1-130 and 1-131. 1. Rib Location Figure 1-130 Cast-in-Rib Front View All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-151