1.8 CRANKSHAFT OIL SEALS 1.8.3 Removal of Front or Rear Crankshaft Oil Seal (Gear Case Cover or Flywheel Housing Still Installed) The crankshaft oil seals may be taken out without removing the gear case cover or flywheel housing. This may be done by using crankshaft oil seal removal tool (J–41329). NOTE: To assist seal removal, thoroughly clean all rust and dirt from the crankshaft surface. Application of penetrating oil to the wear sleeve and crankshaft hub may also aid seal removal. Remove the seal as follows: 1. Install the crankshaft oil seal removal tool (J–41329) over crankshaft and hold against seal. See Figure 1-135. 2.
Using a variable speed drill motor and 5/32 inch drill bit, drill through outer and inner case of seal using the smallest hole “A” as a guide. 3. Without moving the removal tool (J–41329), drill five additional “A” holes equally spaced. See Figure 1-135. Figure 1-135 Removing Front Crankshaft Oil Seal from Gear Case Cover or Flywheel Housing NOTE: Use all six holes to ensure removal is successful. Drive screws carefully, the threads can strip easily when using an electric driver. 4. Remove any metal chips from the face of the seal, the crankshaft and the bore surface. 5. Rotate the removal tool (J–41329) clockwise until the “B” holes align with drilled holes and install sheet metal screws.
(Rev. 2005) All information subject to change without notice. 1-156 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION