Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 6. Apply extreme pressure lubricant (J–23444–A, part of tool set J–41329) to forcing screw and remove seal. NOTE: Seals may be difficult to remove due to debris on the crankshaft preventing the wear sleeve from passing over the crankshaft. Push the seal 1/8 inch, clean the crankshaft surface thoroughly and repeat the removal procedure. Application of penetrating oil to the wear sleeve and crankshaft hub may also aid seal removal. 7. Remove the sheet metal screws from the tool. Discard the oil seal. 8. If a crankshaft oil seal wear sleeve remains installed on the hub of the crankshaft, remove the wear sleeve using the wear sleeve remover (J–37075–A).

Refer to section 1.8.4 for removal instructions. 9. Clean the seal bore in the gear case cover or flywheel housing and clean the surfaces of the crankshaft. NOTE: Crocus cloth may be used to remove dirt, rust and to clean up the high spots from the surface of the crankshaft and gear case cover bore. Thoroughly clean the contact surfaces. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-157