1.8 CRANKSHAFT OIL SEALS 1.8.4 Removal of Wear Sleeve from Crankshaft Hub If the seal that was removed used a separate wear sleeve, the old wear sleeve must also be removed. Use the following procedure to remove wear sleeve. 1. Remove worn wear sleeve using crankshaft wear sleeve remover tool (J–37075–A). See Figure 1-136 2. Install the protective hardened steel sleeve removal tool into the bore of the gear case cover or flywheel housing. Insert tool between protective sleeve and wear sleeve.
Using a socket and breaker bar, rotate tool in three different locations, 2, 4 and 8 o'clock positions, to score the sleeve until sleeve stretches sufficiently enough to be slipped off the end of the crankshaft. NOTE: Crocus cloth may be used to clean up the high spots from the surface of the crankshaft. 3. Thoroughly clean the crankshaft contact surface. Figure 1-136 Rear Oil Seal Wear Sleeve Removal (Rev. 2005) All information subject to change without notice. 1-158 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION