Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.8 CRANKSHAFT OIL SEALS NOTICE: Ensure that the crankshaft hub and bolt surface, gear case cover, flywheel housing bore and contact surfaces of the installation tools are free of dirt, grit, rust or raised metal. Clean thoroughly with crocus cloth if needed. Ensure that an old wear sleeve is not installed onto the crankshaft hub. Refer to section 1.8.4 for wear sleeve removal instructions. NOTICE: The incorrect installation of the oil seal will cause immediate seal leakage, or will reduce the life of the seal significantly. Perform the followings steps to install the front and rear oil seals and sleeves: 1. Lubricate the rubber outer diameter of the oil seal with clean engine oil.

Lubricate the gear case cover or flywheel housing bore with clean engine oil. NOTICE: Failure to lubricate the outside of the seal and the inside of the bore prior to installation may damage seal causing seal to leak. (Rev. 2005) All information subject to change without notice. 1-160 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION