SERIES 60 SERVICE MANUAL 2. Install two guide studs (J–35686–2, part of tool set J–35686–B) through the holes provided in the center guide assembly (J–35686–1, part of tool set J–35686–B) and into two of the tapped holes in the crankshaft 180 degrees apart. Tighten the guide studs using the appropriate wrench on the flats of the studs. The base must be tight against the end of the crankshaft. See Figure 1-137. 3. Install the spacers to the center screw of the base. Refer to Table 1-4 and Figure 1-138. Figure 1-138 Spacer Installation All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-161