Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.8 CRANKSHAFT OIL SEALS 4. Slide the oil seal assembly over the installer base as far onto the crankshaft hub as possible. Slide collar with the stepped side contacting the seal. Slide the installer cup over the guide studs and installer base. See Figure 1-139 and Table 1-4. Figure 1-139 Oil Seal and Sleeve Installation 5. Lubricate the center screw of the base with extreme pressure lubricant (J–23444–A, part of tool set J–41329). Install the thrust bearing with the case side toward the installer cup and install the hex nut to the center screw of the base. See Figure 1-140. Figure 1-140 Thrust Bearing Installation 6. Finger tighten the hex nut until snug. 7.

Install a ratchet and socket onto the hex nut. 8. Tighten the hex nut until the oil seal and wear sleeve are pressed into the flywheel housing or gear case cover. (Rev. 2005) All information subject to change without notice. 1-162 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION