1.9 CRANKSHAFT MAIN BEARINGS NOTICE: Do not mix old and new style thrust washers in the same engine. Engines built after serial number 06R0762048 will accommodate the current style four-piece thrust washer as well as the former style two thrust washer version. See Figure 1-142. The current style thrust washers are marked for front and rear and are designed to directionally rotate into the same upper position with the main bearing cap removed. The No. 6 position main bearings are the same as the other postion. 1. Upper Thrust Washer (2) 4. No. 6 Main Bearing Cap 2. Upper No. 6 Bearing Shell 5. Bolt 3. Lower No. 6 Bearing Shell 6. Thrust Washer (2) Figure 1-142 No.
6 Thrust Bearing Detail The condition of the lower bearing shells may be observed by removing the main bearing caps. (Rev. 2005) All information subject to change without notice. 1-166 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION