1.9 CRANKSHAFT MAIN BEARINGS Inspect the crankshaft thrust washers. If the washers are discolored or worn excessively, or if the crankshaft end play is excessive, replace the thrust washers. Inspect the crankshaft thrust surfaces. Refer to section 1.7.2.1. If, after dressing or regrinding the thrust surfaces, new standard size thrust washers do not hold the crankshaft end play within the specified limits, it may be necessary to install oversize thrust washers on one or both sides of the No. 6 main bearing. A new standard size thrust washer is 3.56-3.48 mm (0.140 -0.137 in.) thick. Thrust washers are available in 0.127 and 0.254 mm (0.005 and 0.010 in.) oversize.
1.9.3 Installation of Main Bearings Shells (Crankshaft Removed) Install the main bearing shells as follows: 1. Check that all of the parts are clean and dry. 2. Apply clean engine oil 360° around each crankshaft main journal and install the upper main bearing shells to their respective saddles in the cylinder block. Note the locating tangs and be sure the oil holes register with the galleries in the cylinder block. 3. Be sure to install the drilled bearing shells in the cylinder block and the plain bearing shells in the bearing caps. The upper and lower main bearing shells are not alike; the upper shell is drilled for lubrication, the lower bearing shell is not.
If they are not installed correctly, the oil flow to the bearings and to the upper end of the connecting rods will be blocked off. Used bearing shells must be reinstalled on the same journal from which they were removed. 4. Perform all of the steps under "Installation of Crankshaft." Refer to section 1.7.3. [a] Measure the main bearing clearances. Refer to section ADDITIONAL INFORMATION1.A, "Checking Bearing Clearances" in "Shop Notes". 5. Measure the crankshaft end play. The minimum and maximum specifications are listed in Table 1-22. 6. Torque all of the main bearing cap bolts to 470-530 N·m (347-391 lb·ft). 7. Measure the main bearing bores with dial bore gage (J–5347–B).
The minimum specifications are listed in Table 1-16. (Rev. 2005) All information subject to change without notice. 1-174 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION