SERIES 60 SERVICE MANUAL Attachment tool (J–4757) placed between the bearing shell and a micrometer, will give an accurate measurement. The bearing shell thickness will be the total thickness of the steel ball in the tool and the bearing shell, less the diameter of the ball. This is the only practical method for measuring the bearing thickness, unless a special micrometer is available for this purpose. The minimum thickness of a worn standard main bearing shell is 3.937 mm (0.155 in.). If any of the bearing shells are thinner than this dimension, replace all of the bearing shells. A new standard bearing shell has a thickness of 3.962-3.980 mm (0.1560 -0.1567 in.).
If any bearing shell shows wear through the overlay across the width of the shell, all bearing shells must be replaced. In addition to the thickness measurement, check the clearance between the main bearings and the crankshaft journals. This clearance may be determined with the crankshaft in place by means of a soft plastic measuring strip that is squeezed between the journal and the bearing as described in "Checking Bearing Clearance". Refer to section ADDITIONAL INFORMATION1.A.
With the crankshaft removed, measure the outside diameter of the crankshaft main bearing journals and the inside diameter of the main bearing shells when installed in place with the proper torque 470-530 N·m (347-391 lb·ft) torque on the bearing cap bolts. When installed, the bearing shells are 0.0254 mm (0.001 in.) larger in diameter at the parting line than 90 degrees from the parting line. The bearing shells do not form a true circle out of the engine. When installed, the bearing shells have a squeeze fit in the main bearing bore and must be tight when the bearing cap is drawn down. This crush assures a tight, uniform contact between the bearing shell and bearing seat.
Bearing shells that do not have sufficient crush will not have uniform contact, as shown by shiny spots on the back, and must be replaced. If the clearance between any crankshaft journal and its bearing shells exceeds 0.1524 mm (0.006 in.), all of the bearing shells must be discarded and replaced. This clearance is 0.040-0.127 mm (0.0016 -0.005 in.) with new parts. If installing new replacement bearings, it is very important to thoroughly inspect the crankshaft journals. Also, damaged bearings may cause bending fatigue and resultant cracks in the crankshaft. Refer to section 1.7.2.11, and refer to section 1.7.2.9. Do not replace one main bearing shell alone.
If one bearing shell requires replacement, install all new upper and lower shells. NOTE: Anytime a new or reground crankshaft is used, all new bearing shells must be used. Bearing shells are available in 0.254, 0.508 and 0.762 mm (approximately 0.010,.020 and 0.030 in.) undersize for service with reground crankshafts as listed in Table 1-10to determine what size bearings are required. Ensure the correct bearing to journal clearance is maintained when using these parts. NOTE: Bearing shells are NOT reworkable from one undersize to another undersize under any circumstances. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-173