Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.9 CRANKSHAFT MAIN BEARINGS To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. EYE INJURY 2. Blow dry the main bearings with compressed air and inspect for damage and wear. Refer to section 1.9.2.2. 1.9.2.2 Inspection of Crankshaft Main Bearings Bearing failures may result from deterioration (acid formation) or contamination of the oil or loss of oil. An analysis of the lubricating oil may be required to determine if corrosive acid and sulphur are present, which cause acid etching, flaking and pitting. Bearing seizure may be due to low oil or no oil.

Inspect the bearings for scoring, pitting, flaking, etching; or signs of overheating. The bearing overlay may develop minute cracks or small isolated cavities (checking) on the bearing surface during normal engine operation. These are characteristics of and are not detrimental to this type of bearing. They should not be replaced for these minor surface imperfections, since function of the bearings is in no way impaired and they will give many additional hours of trouble-free operation. Inspect the backs of the bearing shells for bright spots, which indicate they have been moving in the bearing caps.

If such spots are present, discard the bearing shells, and inspect the bearing caps and upper bearing saddles. Measure the thickness of the bearing shells at a point, 90 degrees from the parting line. See Figure 1-148. Figure 1-148 Main Bearing Measurements (Rev. 2005) All information subject to change without notice. 1-172 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION