Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 15. Position the remover and installer with the bearings in the saddle being worked on and install the main bearing cap bolts and washers. Torque the bolts until they are snug 13-27 N·m (10-20 lb·ft). 16. Using the square hole in the crankshaft pulley, bar the engine over slowly, in a counterclockwise direction, approximately 180 degrees until the bearing split line is even with the cap and block joint face. Care must be taken not to bar the engine over too far and damage the bearing tang. 17. Remove the bearing remover and installer tool set (J–36187–A). 18. Install the lower main bearing shell to be used, into the engine main bearing cap. NOTE:

Thrust washers in the No. 6 main bearing cap are no longer required if the engine was built with them. They do not need to be reinstalled. 19. Coat the threads and underside of the heads of the main bearing cap bolts with International Compound #2®. Position the main bearing cap, with bearing(s) in place into the saddle and install the bolts and washers. Rap the main bearing caps sharply with a fiber mallet or plastic hammer to ensure the caps are fully seated. Torque the bolts to 470-530 N·m (347-391 lb·ft). 20. It will be necessary to reinstall the upper and lower main bearing shells (and the upper thrust washers for the No.

6 main) and the main bearing cap, for the bearings being inspected or replaced before proceeding to the next main bearing saddle. Refer to section 1.9.3. 21. Repeat this procedure for each main bearing saddle until all seven sets of main bearings have been removed and inspected or replaced. NOTE: No. 7 main bearing journal does not have an oil hole, so the bearing remover cannot be used at that position. The No. 7 upper main bearing should be removed with both No. 6 and No. 7 main bearing caps off. Using a suitable tool, push on the No. 7 upper bearing on the side opposite the tang and dislodge the bearing tang from the tang slot in the cylinder block.

Carefully push and pull the bearing the rest of the way out, taking care not to damage the bearing shell. Rotate the crankshaft, and apply some pressure to the side of the bearing while rotating. 22. After removal, clean the bearings. 1.9.2.1 Cleaning of Main Bearings Perform the following to clean the main bearing: 1. Immerse the bearing in cleaning agent. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-171