1.9 CRANKSHAFT MAIN BEARINGS worked on. The word "Front" stamped on the tool must face the front of the engine. Be sure that the roll pin in the oil delivery hole registers with the cutout section of the bearing shell tool before tightening the main bearing cap bolts. See Figure 1-147. Figure 1-147 Upper Main Bearing Shell Remover Tool Installation NOTE: Only the No. 6 main bearing shell requires use of the thrust washers on the sides of the remover tool. For main bearings No. 1, 2, 3, 4, 5, and 7, it will not be necessary to install the thrust washers to the tool. 9. Torque the main bearing cap bolts until they are snug 13-27 N·m (10-20 lb·ft). 10.
Using the square hole in the middle of the crankshaft pulley, bar the engine over in a clockwise direction when viewed from the front, approximately 180 degrees until the tang of the upper main bearing contacts the block. This will roll the bearing shell tool (and the thrust washers for No. 6 main bearing) into the upper main bearing saddle. NOTE: Keep all bearing shells and thrust washers segregated by number, so that they may be reinstalled exactly as removed if the bearing shells are reused. Shells and washers may be marked with a permanent marker or equivalent. Do not punch mark or otherwise disturb the surface of the shells and washers to mark them. 11.
Remove the main bearing cap tool from the saddle. 12. Remove the upper shell (and two thrust washers when working on No. 6 main) from the tool. 13. Inspect the bearing shells (and thrust washers for No. 6 main). Refer to section 1.9.2.2. 14. Install the upper main bearing to be used, in the main bearing installer and remover with the word "Front" facing the front of the engine. If the No. 6 main bearing is being done, install the thrust washers to the bearing. Refer to step 7 in this procedure. (Rev. 2005) All information subject to change without notice. 1-170 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION