Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 5. To bar the engine over, use the square hole in the middle of the crankshaft pulley, to position the crankshaft throw. Position the crankcase throw for the main bearing being worked on so that the oil delivery hole is pointing upward. See Figure 1-145. Figure 1-145 Roll Pin Hole Installation 6. Install the roll pin to the oil delivery hole in the crankshaft journal. See Figure 1-145. If this operation is being performed in-frame, use petroleum jelly to retain the roll pin in the hole. 7. For the No. 6 main bearing journal, it will be necessary to install the lower main bearing thrust washers (previously removed) to the machined faces of the body from the tool kit.

Stick the thrust washers to the main cap using petroleum jelly. Index the locating tangs on the thrust washers with the cutouts on the bearing shell. See Figure 1-146. Figure 1-146 Upper Main Bearing Shell Removal-Tool Set-Up 8. Using the main bearing cap bolts and washer removed from the engine, install the assembled main bearing cap remover and installer tool to the main bearing saddle being All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-169