1.9 CRANKSHAFT MAIN BEARINGS 3. Remove one bearing cap at a time and inspect the lower bearing shell. Refer to section 1.9.2.2. NOTE: If shims are used between the oil pump and the cylinder block, save the shims so that they can be reinstalled in exactly the same location as removed. The shims are used to adjust the crankshaft timing gear-to-oil pump drive gear lash. 4. To remove the upper main bearing shells without crankshaft removal, it will be necessary to use the main bearing shell remover and installer tool set (J–36187–A). See Figure 1-144. NOTE: Remove and reinstall both upper and lower bearing shells for each main journal being inspected before moving on to the next main journal.
Never remove more than one main bearing cap at a time except for No. 6 and No. 7. Figure 1-144 Main Bearing Shell Remover and Installer Tool Set (Rev. 2005) All information subject to change without notice. 1-168 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION