Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.12 GEAR CASE PRE-EXHAUST GAS RECIRCULATION (EGR) 11. Install the crankshaft protector (J–35994) to the oil seal contact area of the crankshaft. This will help to protect the crankshaft seal surface when removing the bull gear and camshaft idler gear assembly. See Figure 1-205. Figure 1-205 Crankshaft Protector Installation 12. Remove the bull gear and camshaft idler gear assembly from the engine. Refer to section 1.33.2. 13. Remove the adjustable idler gear assembly from the gear case. Refer to section 1.30.2. 14.

Using a plastic hammer or fiber mallet, tap the rear face of the camshaft thrust plate to remove the thrust plate, camshaft drive gear hub and camshaft drive gear from the gear case. (Rev. 2005) All information subject to change without notice. 1-220 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION