1.12 GEAR CASE PRE-EXHAUST GAS RECIRCULATION (EGR) 6. Torque the gear case-to-cylinder block bolts to 58-73 N·m (43-54 lb·ft). See Figure 1-212. Figure 1-212 Gear Case Housing Bolt Torque Sequence 7. Remove the gear case alignment plug from the gear case. 8. Install the air compressor. Refer to section 11.1.8. 9. Install the fuel pump drive assembly to the gear case, if so equipped. Refer to section 2.8.5 or refer to section 2.8.6. 10. Install the fuel pump to the fuel pump drive assembly (or air compressor). Refer to section 2.9.3. NOTE: For 1991 and later model year engines, refer to section 4.2.8or refer to section 4.3.7 and install the water pump assembly. 11.
Lubricate the rubber O-ring on the camshaft thrust plate with clean engine oil. Install the camshaft thrust plate assembly, with the camshaft drive gear and hub in place to the gear (Rev. 2005) All information subject to change without notice. 1-226 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION