SERIES 60 SERVICE MANUAL [b] For crankshaft timing gear-to bull gear lash measurement. Perform step 3, refer to section 1.24.2.1. [c] To install the gear case cover. Refer to section 1.10.3. [d] Install the two bolts and nuts securing the left side gear case stiffening bracket to the gear case. Torque to 75–81 N·m (55–60) lb·ft). See Figure 1-216 Figure 1-216 Gear Case Stiffening Bracket (Left Side) [e] Install the bolt securing the left side gear case stiffening bracket to the cylinder head. Torque to 58–73 N·m (43–54 lb·ft). See Figure 1-216 [f] Install the bolt securing the right side gear case stiffening bracket to the gear case.
Torque the former bracket bolt to 58–73 N·m (43–54 lb·ft) or torque the current gear case bracket bolt to 74–81 N·m (55–60 lb·ft). See Figure 1-217 NOTE: Bolts attaching bracket to the gear case are torqued first, then the bolt to cylinder head is torqued next. [g] Install the two bolts securing the former right side gear case stiffening bracket to the cylinder head or one bolt securing the current right side bracket. Torque the former All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-229