1.12 GEAR CASE PRE-EXHAUST GAS RECIRCULATION (EGR) 13. Inspect the bull gear and camshaft idler gear access opening in the gear case and remove any foreign material. 14. Install two bull gear guide studs (J–35785) to the cylinder block. See Figure 1-215. Figure 1-215 Bull Gear Guide Stud Installation NOTICE: Always install crankshaft protector when installing the bull gear and camshaft idler gear assembly to prevent damaging the crankshaft oil seal contact surface. 15. Install the crankshaft protector (J–35994) to the oil seal contact area of the crankshaft. This will help to protect the crankshaft seal surface when installing the bull gear and camshaft idler gear assembly. 16.
Install the bull gear and camshaft idler gear assembly to the guide studs. Align the timing marks on the bull gear and the crankshaft timing gear and the camshaft idler gear and adjustable idler gear; see Figure 1-214, and slide the bull gear and camshaft idler gear assembly forward to seat it in the recess in the gear case and cylinder block. 17. Working through the lightening holes in the bull gear, install two of the bull gear assembly mounting bolts through the hub and into the cylinder block. Finger-tighten the bolts. 18. Remove the two bull gear guide studs. Install the remaining two bull gear assembly mounting bolts. Torque the bolts to 101-126 N·m (75-93 lb·ft).
Tighten in a clockwise sequence. 19. Check the timing marks on the gears to ensure the gear train is properly timed. See Figure 1-214. 20. Perform the following: [a] For crankshaft timing gear-to-oil pump gear lash measurement. Perform step 2, refer to section 1.24.2.1. (Rev. 2005) All information subject to change without notice. 1-228 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION