1.13 GEAR CASE EXHAUST GAS RECIRCULATION (EGR) MODEL 9. Use a rubber hammer or plastic mallet to loosen the gear case from the cylinder block. See Figure 1-227. Figure 1-227 Gear Case Removal EGR Model 1.13.1.1 Inspection of Gear Case EGR Model Inspect the gear case as follows: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. Inspect the gear case as follows: 1. Clean all of the old gasket sealer from the mating surfaces of the gear case, gear case cover, and engine block.
Refer to "Gasket Eliminator Removal," in the "GENERAL INFORMATION" Section at the beginning of this manual. 2. Clean the gasket material from the mating surfaces of any components or access covers that were removed from the gear case cover or gear case. Clean all of the parts with clean fuel oil and dry with compressed air. 3. Remove the oil gallery plug at the top of the gear case. (Rev. 2005) All information subject to change without notice. 1-238 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION