Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 4. Use compressed air to ensure the oil gallery is completely free of blockage. If necessary, use a wire brush to clean the gear case oil gallery. 5. Inspect the gear case for stress cracks, breaks, or other damage. Repair or replace as necessary. 6. Inspect the adjustable idler gear studs for signs of galling or scoring. Replace as necessary. 7. Inspect all the individual components as outlined under the appropriate section. 1.13.2 Installation of Gear Case EGR Model Install the gear case as follows: 1.

Apply a thin coat of Loctite® 518 or equivalent to the rear side of the of the gear case and install a new O-ring on rear side of gear case near air compressor drive opening. See Figure 1-228. 1. O-ring Installation Location 2. Loctite Application Figure 1-228 Gear Case O-ring Installation Location and Loctite Application 2. Install two guide studs into the front of the cylinder block. See Figure 1-229. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-239