Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 3. Thread the center screw of the tool in until the tip of the tool rests between two teeth of the flywheel ring gear. NOTE: It may be necessary to bar the engine over (using the square hole in the middle of the crankshaft pulley or the center bolt when the pulley and hub assembly with spindle is used) so that the tool center screw is exactly between two teeth. 4. Tighten the knurled knob finger-tight. 5. Remove the isolated pulley from the spindle by removing the large center bolt (if equipped with this pulley style). 6.

Remove two of the six crankshaft pulley or crankshaft pulley spindle to crankshaft special attaching bolts and hardened washers that are 180 degrees apart. Discard the bolts. These bolts are not reusable. 7. Install two guide studs (J–36235) into the holes where the bolts were removed. NOTICE: Use care when removing the crankshaft pulley as the vibration damper may come off. If the damper is allowed to fall, internal damage to the damper will result. 8. Remove the remaining four special crankshaft pulley bolts and hardened washers. Discard the bolts. These bolts are not reusable. NOTICE:

Do not pound with a hammer or pry with other tools to remove the viscous damper from the crankshaft, since the outer shell may be dented and cause the flywheel to turn at the same speed as the outer shell. This renders the damper ineffective. The damper CANNOT be repaired. 9. Remove the vibration damper by sliding it off the guide studs. 10. Remove the flywheel lock and guide studs. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-247