Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.14 CRANKSHAFT VIBRATION DAMPER NOTICE: A loose engine mount could lead to damage of the vibration damper by allowing the engine to move slightly during operation. NOTE: It is good practice to periodically inspect the engine mounts to be sure they are not loose, cracked or deteriorated. 1.14.3 Installation of Crankshaft Vibration Damper Install the crankshaft vibration damper as follows: 1. Install the flywheel lock (J–36375–A) to the inspection plug hole in the bottom of the flywheel housing. See Figure 1-234. NOTE: It may necessary to bar the engine over using barring tool (J–36237) so that the tool center screw is exactly between two teeth. 2.

Thread the center screw of the tool in until the tip of the tool rests between two teeth of the flywheel ring gear. Tighten the knurled knob finger-tight. 3. Install two guide studs (J–36235) to two of the holes in the crankshaft pulley 180 degrees apart. A light coating of an antiseize compound should be applied to the pilot diameter (not the face of the crankshaft) to reduce future removal difficulty. 4. Install the vibration damper to the end of the crankshaft. The six holes in the damper are equally spaced, and the damper may be installed in any position. The part number on the face of the damper should face out, away from the engine. 5.

Install the crankshaft pulley or crankshaft pulley spindle to the crankshaft. The crankshaft pulley or crankshaft pulley spindle may be installed in any position. Refer to section 1.15.3. NOTICE: Crankshaft pulley and spindle mounting bolts are considered single-use items and must not be reused. Always use new bolts when mounting the crankshaft pulley or spindle. Reusing bolts may result in excessive bolt stretch during installation, leading to loss of bolt torque and loosening during engine operation, which may cause severe engine damage. 6. Install four new special bolts, with hardened washers installed, through the pulley or crankshaft pulley spindle and damper and into the crankshaft.

Finger-tighten the bolts. 7. Remove the two guide studs. 8. Install the remaining two new special bolts with hardened washers installed. (Rev. 2005) All information subject to change without notice. 1-250 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION