SERIES 60 SERVICE MANUAL The crankshaft pulley is of the rigid design. Six bolt holes through the pulley are equally spaced. A relief area is machined around each bolt hole and acts as a seating surface for the hardened washers. See Figure 1-237. Figure 1-237 Crankshaft Pulley Cross-Section Four 12.7 mm (0.50 in.) vee-type grooves in the crankshaft pulley provide drive belt seating surfaces. A 3/4 in. square drive hole in the center of the crankshaft pulley allows the use of a 3/4 in. drive breaker bar or ratchet for barring the engine over. See Figure 1-238. Figure 1-238 Barring Engine Over All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-253