1.15 CRANKSHAFT PULLEY 1.15 CRANKSHAFT PULLEY Two crankshaft pulley arrangements exist. Some early engines were built with a pulley, a crankshaft pulley hub and woodruff keys. Later engines are built with the crankshaft pulley bolted directly to the crankshaft. For the crankshaft pulley bolted directly to the crankshaft, see Figure 1-236. In this case the pulley is attached to the crankshaft with six special bolts and washers. The vibration damper is clamped between the crankshaft pulley and the crankshaft. NOTE: Do not substitute any other bolts or washers. The crankshaft pulley bolts and washers are special parts. These bolts are not reusable.
Figure 1-236 Crankshaft Pulley Mounted Directly to the Crankshaft (Rev. 2005) All information subject to change without notice. 1-252 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION