Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL NOTICE: Use care when removing the crankshaft pulley as the vibration damper, which is slip fitted over a pilot diameter of the crank, may come off. If the damper is allowed to fall, internal damage to the damper will result. 8. Remove the remaining four crankshaft pulley bolts and hardened washers. Discard the bolts. These bolts are not reusable. 9. Remove the crankshaft pulley by sliding it off the guide studs. NOTE: Leave the guide studs in place to prevent the vibration damper from falling off. Remove the spindle-mounted pulley and hub assembly as follows: 1. Remove the drive belts from the crankshaft pulley. 2.

Remove the inspection plug in the bottom of the flywheel housing. 3. Install the flywheel lock (J–36375–A). See Figure 1-243. Figure 1-243 Flywheel Lock All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-257