Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.15 CRANKSHAFT PULLEY 4. Thread the center screw of the tool in until the top of the tool rests between two teeth of the flywheel ring gear. NOTE: It may be necessary to bar the engine over using the crankshaft pulley bolt so that the tool center screw is exactly between two teeth. 5. Finger-tighten the knurled knob. 6. Loosen the center bolt holding the pulley and hub assembly to the spindle. See Figure 1-244. Figure 1-244 Crankshaft Pulley and Hub Assembly Installation with Spindle 7. With the pulley properly supported, remove the bolt and washer and pull the pulley and hub assembly off of the spindle. 8.

Remove two of the six spindle-to-crankshaft attaching bolts and hardened washers that are 180 degrees apart. Discard the bolts. These bolts are not reusable. 9. Install two guide studs (J–36325) to the holes from which the bolts were removed. (Rev. 2005) All information subject to change without notice. 1-258 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION