SERIES 60 SERVICE MANUAL NOTICE: Use care when removing the spindle as the vibration damper, which is slip fitted over a pilot diameter of the crank, may come off. If the damper is allowed to fall, internal damage to the damper will result. 10. Remove the remaining four spindle attaching bolts and hardened washers. Discard all six bolts. These bolts are not reusable. 11. Remove the spindle by sliding it off the guide studs. NOTE: Leave the guide studs in place to prevent the vibration damper from falling off. 1.15.2.1 Inspection of Crankshaft Pulley or Spindle and Crankshaft Pulley and Hub Assembly Inspect the crankshaft pulley, spindle or hub assembly components as follows: 1.
Inspect the crankshaft pulley or spindle and crankshaft pulley and hub assembly. NOTICE: A loose or bent crankshaft pulley or spindle, after extended operation, may result in a cracked crankshaft. [a] Determine if the crankshaft pulley or spindle is bent, broken or has cracked edges. [b] If damage is detected, replace with a new part. [c] If damage to the crankshaft pulley, pulley and hub assembly or spindle is extensive, refer to section 1.14.2.1, and inspect the vibration damper. Inspect the crankshaft, refer to section 1.7. 2. Inspect the drive belt seat grooves. [a] Check drive belt seat grooves for bent flanges or a rough belt seating surface.
[b] Smooth rough seating surfaces with an emery cloth or a stone. [c] If flanges are bent, replace the pulley. 3. Inspect the retaining bolt seat relief areas. [a] Check relief area for stress cracks. [b] If stress cracks are discovered, replace the pulley or spindle. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-259